![]() ![]() Undo the inserted vertex by exiting the Edit Vertex option (X.J) and typing U.J.Ģ. Move In this brief exercise, you’ll use the Move option to move a vertex.ġ. ![]() If the polyline is curved, the new vertex will not immediately be shown as curved (see the top image of Figure 13.11).You must smooth it out by exiting the Edit Vertex option and then using the Fit option, as you did to edit the site plan (see the bottom image).You can also use the Stretch command (on the Modify toolbar) to move a polyline vertex. ![]() Notice that the inserted vertex appears between the currently marked vertex and the next vertex, so the Insert option is sensitive to the direction. When the X is in the proper position, pick Go from the Edit Vertex menu or enter G.J, and the polyline will be broken. At the Enter an option : prompt,use Next or Previous to move the X to the other end of the segment to be broken.Ĥ. When the X is in the proper position, pick Go from the Edit Vertex menu or enter G.J, and the polyline will be brokenģ. Next or Previous to move the X to the other end of the segment t~ be broken.Ĥ. Position the X on one end of the segment you want to break.ģ. Notice that now the default option becomes P.ġ. (Because Next is the default option, you only need to press u to move the X.)Ģ. J a couple of times to move the X along the polyline. As you select Next or Previous, theX moves from vertex to vertex to show which one is being edited. Edit Vertex, is almost like a command within a command.Edit Vertex has numerous suboptions that allow One o(the Pedit options that hasn’t yet been discussed. Turning Object into polylines and polylines into sublines. Next, you’ll use this polyline curve to experiment with some of the editing options uniqu'”eto the Pedit command. line segments, and the curve of each arc depends on the direction of the adjacent arc. The Fit curve option under the Pedit command causes AutoCAD to convert the straight-line segments of the polyline into arcs. The endpoints of the arcs pass through the endpoints of,the. This causes the polyline to smooth out into a series of connected arcs that pass through the data points. At the PEOIT Select objects: prompt, pick ithe contour line you just drew.Įnter an option [close/JoinjWidth/Edit vertex/Fit/Spline/ Next you will convert the polyline you just drew into a smooth contour line.ġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |